Skip to main content

FRITZ!DECT

Updated

AVM offers with its smart sockets FRITZ!DECT One way to control electrical devices smart. You can have them controlled by integration with us using your excess solar flow or dynamic price signals. But you can also go to them Monitoring of energy consumption or the Creation of your mini-PV system use.

⚠️ References

Needs Fritz! Box version 7.57+

Needs IPV4 access

It could happen that due to our access, warnings will be sent to the stored MyFRITZ! Address by email. These can be deactivated.

Preparation

In order for the FRITZ! DECT work, the FRITZ! Box must be accessible via an IPV4 address.

 

Die Fritz!Dect 200 or Fritz!Dect 210 Sockets have to be used with the Fritz!Box be connected.

Since the Fritz!Dect Splares can initially only be reached locally during the furnishings, it is necessary to make certain settings in order to make them accessible via the Internet. This is done in two steps.

  1. A MyFritz! Account must create and in the Fritz!Box be stored. This makes the smart plugs available for us.
  2. A Fritz!Box-Benutzer With permissions for smart home and internet, the FRITZ! Box must be set up. 

Steps to integrate

Creating a My-Fritz!

Create a MyFritz! Account and put it in your FRITZ! Box according to the steps one and two the official documentation of AVM. After the setup, the MyFritz! be created. A successful configuration in the FRITZ! Box could look like this:

 
  1. "Your MyFritz! Address" must be entered completely in the app
  2. The username must be created under System> FRITZ! Box user

⚠️ scroll down after setting up internet access and put the check mark [✔] at [Certificate of letsencrypt.org use (recommended)]. Then click on [Take over].

 
 
 

Creating a FRITZ! Box user:

In the second step a Guest access be created. Guide this according to Step three the Official AVM documentary through. A user is created here who allows us to connect to the FRITZ! Box to control the devices.

Create a new user for this:

  • Username: MaxMustermann
  • Password: Use a secure password
  • Fuck [✔] at [Smart Home] set
  • Fuck [✔] at [Access also allowed from the Internet] set 
 

Under [Fritz!Box Benutzer] -> [User] a new entry was added. A successful configuration could look as follows:

 
 
 

Integration

The following information is required for integration, which should already be stored in the FRITZ! Box:

  • user name
  • password
  • MyFritz! Internet access including port indication
 
 

Now select the device:

 
 

Select and create switch settings:

 
 
 
 
Powered by Zendesk